Z-Wave Smart Floodlight Sensor

Our Z-Wave smart floodlight sensor reports back to your smart home hub when motion is sensed and when dusk or dawn happens. HS-FLS100 G2 can be programmed to control your floodlights automatically or remotely when commands are received from your smart home software or hub.

Main Features

Motion (PIR) sensor (Now with adjustable sensitivity)
Light sensor (up to 900 LUX)
Temperature Sensor
Floodlight power control (up to 300 watts).
May be used with 120V incandescent or LED floodlight bulbs
Controller-adjustable motion timeout and light sensitivity
Fits most standard floodlight mounting brackets
Easy replacement for non-Z-Wave sensors
Works nicely with conventional floodlight fixtures such as this one

Typical Uses

HS-FLS100 G2 is an outdoor MOTION, TEMPERATURE and LUX sensor that may be used in a variety of ways:

Automatically turns on floodlights when motion is sensed and it's dark (Conventional Mode).
Turns floodlights on or off when it receives Z-Wave commands from controller (Smart Mode).
Sends Z-Wave commands when motion is sensed or has not been sensed for a period of time.
Sends LUX information to controller using Z-Wave commands.
Sends Temperature information to controller using Z-Wave commands.

HS-FLS100 G2 can be used as a retrofit sensor replacement for most motion-activated floodlight fixtures. The motion timeout interval and LUX sensitivity are adjustable via Z-Wave commands.

Video

Specs

Power: 120v / 60Hz
Maximum Load: 300 watts (incandescent) or 100 watts (LED)
PIR Angle of Detection: 120°
PIR Max Range: 39 feet (12 meters)
LUX Range: 0 - 900
908 MHz Z-Wave frequency
ETL, FCC, Z-Wave certified
IP44 Rating for outdoor use

Downloads

Included

HS-FLS100 G2 floodlight sensor
Mounting arm
(3) crimp connectors
Installation guide

Important

This sensor is designed for 120 VAC use and will work with most conventional floodlight fixtures that are wired with 120 VAC lamp sockets. It is NOT compatible with low voltage fixtures. If you have a low voltage fixture, you will need to replace it to use this sensor.